Notifications
Clear all
Hardware Forum
7
Posts
4
Users
0
Likes
245
Views
Nov 16, 2022 5:58 pm
Sorry, files were not uploaded on above post because they exceeded maximum upload size on the posts. I sent an email to you directly. We will see if we can increase the upload size here.
Sreekanth
Nov 19, 2022 3:42 am
Hi everyone,
Thanks for being so helpful! I'm currently trying to learn how to use the AtlasViewer software, and so I'm not sure if my probe.SD file would 3D-print well. I really apologize for the delay in my response.
I've attached my probe.SD file ("probe-rev1.SD"), in case it's possible to convert it to an .STL. If it's printable, I'll follow up on this with the finished print!
Edit: 'probe-rev1.SD' is available here.
Best,
Colin
Page 2 / 2
Prev