Production settings for single optodes Ninja 2021
I am planning to order a fabrication of the single optodes detectors and source optodes PCBs of the Ninja 2021 via the PCB way, I have no knowledge of electronics, so I am a little bit confused. Could you help me to establish which producing setting is required?
please see the attached screenshot for settings that should work.
Please note that the NinjaNIRS project is not really "plug and play". If you only have limited electronics experience, it would be good to have someone more experienced in your team in case something goes not as planned and you need help debugging.
Thank you for the answer. I understand it's not a plug-in-and-play solution and I have a tech guy who will be helping with assembly. Can you check whether these gerbers were appropriately converted?